Philips PMDVR8 Manual De Instrucciones página 5

Button Functions, cont.
Audio Functions (labeled in Red)
PRESET Used to operate preset channels while in Audio
Mode.
AM/FM Lets you to select the AM/FM band on your
audio receiver.
CD, TAPE, TUNER, TV, VIDEO 1, and VIDEO 2
Used to select your audio receiver's input source.
(Works in AUDIO Mode, i.e. after pressing Red AUDIO
button).
FUNCTION Selects the different audio input devices.
The number buttons also select the function labeled
above the buttons when in AUDIO Mode.
LEVEL+/LEVEL - Sets the level of the speakers during
test tone Mode.
DSP ON/OFF Enables the receiver's Digital Signal
Processing (DSP) Mode.
DSP MODE When the DSP Mode is enabled, pressing
this button lets you cycle through the various DSP
Modes.
PROG Lets you program the playback order of tracks on
your disc.
DELAY - and DELAY+ Increases or decreases the delay
between the surround and main speakers when your
receiver is in the surround sound Mode.
ON/OFF, SURR, MODE ON/OFF SURR toggles the
surround Modes on and off. SURR MODE cycles
through your receiver's various surround sound Mode
settings.
F, C, R, T (Front, Center, Rear, and Test) Adjusts the
levels of the front, center, and rear speakers respectively.
Used with Level + /Level - . The test tone must be
enabled first by pressing the TEST button.
TV/VCR/DVR
When in TV mode the TV/VCR/DVR button performs
the INPUT source switch function.
When in a mode that has been programmed for VCR the
TV/VCR/DVR button performs the TV/VCR antenna
switch function.
When in a mode that has been programmed for Cable the
TV/VCR/DVR button performs the A.B switch function.
When in a mode that has been programmed for SAT the
TV/VCR/DVR button performs the TV/SAT switch
function.
When in a mode that has been programmed for DVD the
TV/VCR/DVR button performs the DVD Setup function.
8
Setup
Battery Installation
1. On the back of the remote,
push down on the tab and
lift the cover off.
2. Match the batteries to the
+ and - marks inside the
battery case, then insert 2
AAA Alkaline batteries.
3. Press the battery cover
back into place.
Battery Saver
Your remote automatically turns off if the buttons are
depressed more than 30 seconds. This will save your
batteries should your remote get stuck in a place where
the buttons remain depressed (e.g., between the sofa
cushions).
Code Saver
Codes are stored in permanent memory while you are
changing batteries so you will not lose any codes
stored in the remote while you are changing batteries.
Power-On Default
The remote powers on in TV mode.
Code Setup
The CODE SEARCH button is used to setup the
remote. You can either setup the remote using the code
for your brand of product, from the code tables (on
separate sheet), or you can search through the library
of codes until you find a code that works for your
product.
Please refer to "Code Search" on page 10 for more
information on using the code search feature to learn
how to search through the library of codes for your
products.
NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the
CBL button, or a DVD code under the VCR button, etc.
However, you can only store TV codes under the TV
button.
9