Using The Remote Control; Loading Batteries; How To Use The Remote Control - Sharp CV-P10PR Manual De Funcionamiento

USING THE REMOTE CONTROL

LOADING BATTERIES

1
Remove the battery cover.
2
Insert two batteries.
• Make sure the (+) and (-) polarities are cor-
rectly aligned.
• Lines will appear on the display when bat-
teries are properly installed.
3
Reattach the battery cover.
4
Press the RESET button using a thin
pointed implement.
NOTES:
• The battery life is approximately 1 year in normal
use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time, re-
move the batteries from the remote control.

HOW TO USE THE REMOTE CONTROL

Point the remote control toward the Signal re-
ceiver and press the desired button. The unit
generates a beep when it receives the signal.
• Make sure nothing, such as curtains, blocks the
signal receiver window.
• The signal effective distance is 7 m.
CAUTION:
• Do not expose the receiver window to direct sun-
light. This may adversely affect its operation.
• Use of certain fluorescent lamp in the same room
may interfere with transmission of the signal.
• Do not leave the remote control in direct sunlight
or near a heater. Protect the remote control from
moisture and shock.
To prevent the remote control from being
misplaced, hook it to the unit when not in
use.
When attached, to remove the remote control from
the unit, lift the remote control up slightly and pull it
out.
(AAA(R03))
GB-8
Battery cover
Remote control hook