Using The Remote Control - Whirlpool ACP092PR0 Manual De Uso Y Cuidado

Temperature
1. Press the plus button to increase the temperature 2ºF (1ºC).
2. Press the minus button to decrease the temperature 2ºF
(1ºC).
NOTES:
In the Cooling mode, the temperature can be set between
64ºF (18ºC) and 90ºF (32ºC).
In Fan Only mode, the temperature cannot be set.
To change the temperature display from ºF to ºC, press and
hold the plus and minus buttons for 3 seconds.
Time of Day
1. Press and hold TIMER and TIMER OFF. "12:00" will be
displayed.
2. Press the plus or minus button to set the time (24-hour clock).
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER OFF. Timer "OFF 00:00" indicator light will flash.
2. Press the plus or minus button to change the delay time (1 to
24 hours).
3. Press TIMER OFF again. Timer "OFF 00:00" indicator light will
remain on.
To turn the air conditioner on or off:
Press the power button.
Mode
1. Press COOLING to cool the room.
8
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Timer "ON 12:00" indicator light will flash.
3. Press the plus or minus button to change the delay time (1 to
24 hours).
4. Press TIMER again. Timer "ON 12:00" indicator light will
remain on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn off air conditioner.
2. Adjust Mode to ComfortMode
Only.
3. For Cooling mode:
Adjust fan speed to High, Low or Auto.
Adjust temperature between 64ºF (18ºC) and 90ºF (32ºC).
4. For Fan Only mode, adjust fan speed to High or Low.
5. For ComfortMode
temperature up or down by 4ºF (2.2ºC)
NOTE: In Fan Only mode, temperature cannot be set.
6. Press TIMER. Timer "ON 12:00" indicator light will flash.
7. Press the plus or minus button to change delay time (1 to
24 hours).
8. Press TIMER again. Timer "ON 12:00" indicator light will
remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER OFF for 3 seconds. Timer indicator light
will turn off.
To see or change the remaining time (in hours):
1. Press TIMER or TIMER OFF once after it has been
programmed.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.

Using the Remote Control

2. Press DRY to remove moisture from the room without
cooling.
NOTE: Dry operates on Low fan only. Fan Speed button will
not operate in this mode.
3. Press FAN to run fan without cooling. Press FAN SPEED to
choose High or Low.
™ control, Cooling, Dry or Fan
™ control and Dry modes, adjust