Metra 95-8734 Instrucciones De Instalación página 3

KIT PREPARATION
1. Attach the panel brackets to the radio
trim panel with the two supplied
#6 x 3/8" Phillips screws. (Figure A)
2. Secure the climate control to the radio
trim panel with the factory screws.
(Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)
KIT ASSEMBLY
1. Attach the (2) supplied panel clips to
the radio housing. (Figure A)
2. Attach the radio brackets to the radio
using screws supplied with the radio,
and then secure into the dash opening.
(Figure B)
Note: The radio mounting screws must
be flush in the brackets so the radio
assembly will fit into the dash opening.
Screws have been provided in the
event they were not provided with the
aftermarket radio.
3. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
4. Snap the radio trim panel over the radio
and reassemble the dash in reverse
order of disassembly.
(Figure A)
(Figure B)
REV. 3/27/24 INST95-8734
3