e) Disconnect charging source and load prior to installing
or maintaining the battery.
f) Remove battery grounds during installation and maintenance
to reduce likelihood of shock. Remove the connection from
ground if any part of the battery is determined to be grounded.
•When changing batteries, replace with the same quantity and the same
type of batteries.
• Do not attempt to dispose of batteries in a re. It could cause explosion.
•Do not open or mutilate batteries. released electrolyte is harmful to the skin and eyes.
It may be toxic.
•Please replace the fuse only by a fuse of the same type and of the same amperage in
order to avoid re hazards.
•Do not dismantle the UPS, except the quali ed maintenance
•person.
1.4 Transport
•Please transport the UPS only in the original packaging (to protect against shock and
impact).
1.5 Storage
•
e UPS must be stockpiled in the room where it is ventilated and dry
NOTE:
is equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules.
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Ope-
ration of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense
6
ese limits are designed to
is equipment generates, uses, and can