Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTALLING THE CONTROLLER:
off control knobs (if unit is equipped
with knobs) and separate the controller
cover from the mounting plate. Secure
the mounting plate to a stud allowing
the thermostat holes in the back of the
mounting plate to be uncovered and
within the air flow of the fan. Connect
the controller to your power supply as
per illustration 4 or 5. Replace cover and
knobs.
4. WIRING THE CONTROLLER:
wiring is below.
NOTE:
A few hours of operation without
apparent problems does not necessarily
imply that the installation is safe.
DANGER:
Do not substitute a solid state
speed control for the thermostatically
controlled on-off switch that comes with
this fan. Use of a solid state speed control
can result in a fire, causing serious injury or death.
DANGER:
Make sure the circuit breaker powering the circuit on which
the fan will operate is turned OFF before wiring the controller. You can
be shocked or electrocuted if the breaker is not off.
WIRING THE THERMOSTAT - MODELS WCGB, WCGA, AND APG
Connections
Connected at the
factory - Do Not
Disconnect
Illustration 4
CONTROLLER
OPERATION: The thermostat operates on a "fan-off"
temperature setting. Recommended setting is 100-110 degrees Fahrenheit.
The fan will start automatically when the attic temperature rises above the
setting and will shut off when the attic is cooled down to the thermostat
setting.
5. CONTROLLER OPERATION FOR THE COMBINATION HUMIDISTAT/
THERMOSTAT.
THERMOSTAT:
The thermostat operates on a "fan-off" temperature
setting. Recommended setting is 100-110 degrees Fahrenheit. The
fan will start automatically when the attic temperature rises above
the setting and will shut off when the attic is cooled down to the
thermostat setting.
HUMIDISTAT:
The humidistat operates on a "fan-off " setting.
Recommended setting is between 60% to 70% relative humidity. The
fan will start automatically when relative humidity rises 4% to 8%
above the setting, and will shut off when relative humidity reaches
the setting. The control is adjustable to provide flexibility of use. If you
feel that the recommended setting causes the fan to operate longer,
a higher setting may reduce running time. However, with a higher
setting you run the potential risk of higher moisture levels in the attic
and possible moisture-related damage.
airvent.com
| 800-AIR-VENT (247-8368) |
Pull
Illustration 2
Diagram for
Illustration 3
Your
Your power supply
WHITE
BLACK
Attach ground to
screw here
WIRING THE THERMOSTAT/HUMIDISTAT - MODEL APGH
Illustration 5
DANGER: Switch the power off at the service panel and lock the
service panel before servicing the motor. This fan is thermostatically
controlled - it may start at any time if the power is not switched off
at the service panel. Contact with the fan blades while the fan is
operating can result in serious injury.
WARRANTY AND REPLACEMENT PLUS PROTECTION
LIFETIME LIMITED WARRANTY
The Gable-Mount Power Attic Ventilator has a lifetime limited
warranty from date of purchase against defects in workmanship
and materials. This warranty covers fan blade, motor, thermostat
(humidistat/thermostat for Model APGH) and housing. If you
believe any part is defective, call 1- 800-527-1924 for Customer
Service. If it's determined that parts need to be returned to Air
Vent, they must be shipped freight prepaid to Air Vent, 4117
Pinnacle Point Drive, Suite 400, Dallas, TX 75212-1569. If found to
be defective following examination by Air Vent, Inc., any defective
part will be replaced free of charge and returned freight prepaid.
This warranty does not cover any labor costs, including those
required for field repair or replacement or removal of any allegedly
defective part. This warranty gives you specific legal rights and you
may also have other rights which vary from state to state.
Refer to the table below for your products warranty terms. Go to
airvent.com for warranty and Replacement Plus Protection details.
Product
Gable-Mount
Power Fans
Gable-Mount
Power Fans with
Thermostat
Gable-Mount
Power Fans
This warranty is effective on Gable-Mount Power Attic Ventilators
sold after February 1, 2006.
Proof of purchase is required when requesting warranty service.
The original purchaser must present a sales receipt or other
document that establishes proof of purchase. Please do not ship
your fan or any fan parts to Air Vent unless requested to do so.
ventilation@gibraltar1.com
GABLE MOUNT POWER FAN
INSTALLATION INSTRUCTIONS
Attach ground to
screw here
White
Black
Your power supply
Connected at the factory - Do Not Disconnect
Model
Warranty
Number
Plus
Limited
APG,
Lifetime
APGH
Warranty
10 Year
WCGB
Limited
Warranty
5 Year
WCGA
Limited
Warranty
GMPFII010224E
Replacement
protection
TM
5-year
Replacement
Plus
protection
TM
5-year
Replacement
Plus
protection
TM
2-year
Replacement
Plus
protection
TM
Publicidad
