Publicidad
IMPORTANT! The diagrams and figures in this instruction are illustrative and
indicative only. Follow exactly the instructions and sequence for assembling
and operating with the product. Check the securing of the fixation after each
operation. Fixing a certain position in most cases is accompanied by a clicking
sound.
COMPONENTS – FIGURE PD
1. Soft upholstery seat; 2. Baby walker's body; 3. Frame connecting the body
to the base of the walkerм 4. Base of the walker; 5. Wheels; 6.Music board
with toys.
PRODUCT ASSEMBLY
Strictly follow the instructions and sequence for assembling the product as
shown in the diagrams from 1 to 5.
1.Unfold the walker (figure 1). Position the walker at the desired height, then
lock it as shown in Figure 1a.
2.Attach the seat to the walker, as you insert the clamps in the corresponding
openings. Tighten with a screw (figure 2).
3.Put the music toy board into the groove on the upper tray. The soundboard
is correctly positioned when you hear a clicking sound.
4. Place front and back wheels under the walker's base, as shown on figure 4.
Place the stoppers on the walker's basis (figure 4). You don't need any tools to
secure them.
IMPORTANT INFORMATION FOR THE BATTERIES – FIGURE 5:
Find the battery compartment cover.Use a screwdriver to loosen the cap
screws. Take it off. Insert 2 1.5 V type AA batteries (not included), observing
the polarity marked on the bottom of the compartment. Put the battery cover
back on and tighten the screws with a screwdriver. Do not overtighten. Always
use 2*1.5V "AA" batteries.
WARNING!
•
Only an adult should handle the batteries.
•
Keep children away from batteries. NEVER allow children to play with or
charge the battery.
•
Always use new batteries.
•
If you are not going to use the product for a long time, remove the
batteries.
ASSEMBLY INSTRUCTIONS
18
Publicidad
