Levenhuk Ermenrich Wett TU30 Guia Del Usuario página 4

• Press the MEM/READ button (3) to record the current readings in the device memory. Press and hold this button for 2 seconds to activate
the recorded data viewing mode. Use the REC/
the H button (8) for 2 seconds to delete all of the data from the device memory. Press and hold the MEM/READ button (3) for more than
2 seconds to return to measurements.
• The device turns off automatically after 30 minutes of inactivity. The function is enabled by default (the
press and hold the H button (8) while turning on the power. To restore the function, turn the device off and on again.
Specifications
Temperature, range
Temperature, accuracy
Humidity, range
Humidity, accuracy
Wet bulb temperature, range
Wet bulb temperature, accuracy
Dew point temperature, range
Dew point temperature, accuracy
Power supply
Safety ratings
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Do not use the device if it is damaged or does not operate properly. Replace the battery as soon as the low battery indicator lights up.
Do not use solvent to clean the device. Protect the device from sudden impact and excessive mechanical force. Never attempt to operate
a damaged device or a device with damaged electrical parts! Only use accessories and spare parts for this device that comply with the
technical specifications. If a part of the device or battery is swallowed, seek medical attention immediately. Keep away from children.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
device after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as
prescribed by your country's laws.
Ermenrich Warranty
Ermenrich products, except for their accessories, carry a 5-year warranty against defects in materials and workmanship. All Ermenrich
accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty
entitles you to the free repair or replacement of the Ermenrich product in any country where a Levenhuk office is located if all the warranty
conditions are met.
For further details, please visit: levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
Термохигрометър Ermenrich Wett TU30
BG
Комплектът включва: термохигрометър, ръководство за потребителя и гаранция.
Да започнем
• Развийте винтовете на капака на отделението за батериите и махнете капака.
• Поставете 3 батерии AAA, като спазите правилния поляритет.
• Поставете капака на отделението за батериите и завийте винтовете.
• Натиснете захранващия бутон (6), за да включите/изключите устройството.
▲ ▼
(5) and DP/WB/ (7) buttons to navigate through the device's memory. Press and hold
3pcs alkaline AAA batteries (1.5V)
4
–20... +60°C (–4... 140°F)
0... +45°C: ±1.0°C
other: ±1.5°C
0–99.9%
20–80%: ±3.0% RH
other: ±4.0% RH
–20... +60°C (–4... 140°F)
0... +45°C: ±1.0°C
other: ±1.5°C
–50... +60°C (–58... 140°F)
0... +45°C: ±1.0°C
other: ±1.5°C
EN61326-1
icon on the screen). To cancel,