2N IP ONE Manual Del Usuario página 2

Product Overview
Read this manual carefully before using the product and follow the instructions and
recommendations included therein. Refer to wiki.2n.com for complete user documentation.
2N IP One is an elegant yet solid and mechanically resistant IP video intercom designed for
residential buildings. It provides a reliable access control and easy interoperability with other
systems for a higher building security. Thanks to SIP support and compatibility with major IP
PBX and phone manufacturers, it can benefit from all VoIP network services.
Installation Requirements
• LAN connection, UTP cable Cat5 or higher with an RJ-45 connector.
• PoE 802.3af or 12 V DC / 2 A power supply.
• Completed flush mounting.
Mechanical Installation
The device is designed for flush mounting.
Device Installation
Let the walling material harden after finishing the masonry and wall surfacing and remove
the blank.
The package includes an L-shaped plastic plate and 3 Torx head screws. Cut 1 - 2 mm off the
upper part of the cylinder-shaped rubber on the plate. Pull the cable through the remaining
part. Use a crimping tool to crimp the cable connector and insert it in the terminal. Cover the
terminal space with a plate and screw it.
Insert the metal device body into the walled-in box and fit it on the bottom using a Torx head
screw.
!
• Before starting the mechanical installation on a selected place, make sure carefully that
the preparations associated with it (drilling, wall cutting) cannot damage the electrical,
gas, water and other existing wires and pipes.
• Keep the maximum tightening torque of 0.5 Nm.
• The warranty does not apply to the product defects and failures arisen as a result of
improper mounting (in contradiction herewith). The manufacturer is neither liable for
damage caused by theft within an area that is accessible after the attached electric lock
is switched on. The product is not designed as a burglar protection device except when
used in combination with a standard lock, which has the security function.
Electrical Installation
Overview of Main Unit Connectors
Main Unit Connector Configuration
OUT
RELAY
1
Active switch output: 12 V DC, max. 600 mA
Terminals for 20 V AC or 30 V DC switched voltage, 1A NO contact
EN
EN
1
2
3
4