Casselin 700 Serie Manual Del Usuario página 21

List of articles:
1- Burner tube
2- IMBUS brand M5x16 screw
3- Nozzle support
4- Supply pipe - copper
5- Burner nozzle
6- Gas tap
Nozzle replacement procedure:
1) Loosen the IMBUS brand M5x16 screw (position 2)
2) Move the nozzle support (position 3) downwards
3) Unscrew the nozzle (position 5) using a wrench and replace it with the nozzle of the required size
4) Move the nozzle support upwards to distance H
5) Tighten the IMBUS brand M5x16 screw.
The distance H is the nominal dimension in mm between the nozzle support and the burner pipe (position 1).
The values are verified by the testing institute.
Ignition of the burner and adjustment of the power
Turn the relevant burner adjustment knob (A) to the "main burner ignition" position, then press and hold it. Light
the burner with a lighter or matches. After lighting the burner, hold button (A) pressed for several seconds until
the hot melt becomes hot. Then release the button. If the flame goes out, repeat the entire process.
Power reduction performance:
By turning the knob (A) to the "reduced power" position, you regulate the combustion of the burner at reduced
power (lower performance).
How to turn off the burner:
Turn the knob (A) to position "0"
Off button
Full power
Reduced power
EN