Publicidad
Idiomas disponibles
Idiomas disponibles
Nut
Locking Teeth
Blade
f
Locking Hole_
Fig. 10
side is facing away from the blade.
3.
Insert the long end of the provided Allen wrench between the
Locking Teeth and into the Locking Hole in the bushing (Fig. 10).
4.
While holding the Allen wrench in the hole, start the nut onto the
shaft by hand making sure to turn the nut COUNTERCLOCKWISE
to tighten.
5.
While continuing to hold the Allen wrench in the hole and using a
13 mm socket wrench, turn the nut in a COUNTERCLOCKWISE
direction until tight.
6.
Remove the Allen wrench from the Locking Hole.
7.
Place the blade guard over the blade and align the holes in it with
the holes in the housing.
8.
Insert the screws into the blade guard holes and hand start them
to tighten.
9.
Finish tightening the screws using the provided Allen wrench.
Replacing the Pruner Blade
If you need to replace the pruner blade, you can replace it with a
5.5-inch 100-tooth circular saw blade.
CLEANING
Use a small brush to clean off the outside of the unit. Do not use strong
detergents. Household cleaners that contain aromatic oils such as pine
and lemon, and solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
STORAGE
• Lock up the unit to prevent unauthorized
use or damage.
• Store the unit in a dry area.
• Store the unit out of the reach of children.
LONG TERM STORAGE
1.
Follow Removing the Pruner Blade instructions.
2.
Thoroughly clean the unit and inspect for any loose or damaged parts.
3.
Repairor replace damaged parts and tighten loose screws, nuts or bolts.
4.
Follow Installing the Pruner Blade instructions to reinstall the
blade and blade guard. The unit is ready for storage.
TRANSPORTING
• Secure the unit while transporting.
• Cover the blade so that the blade edges will not come into contact
with anything.
Approximate
Operating Weight of Attachment
...............................................................
3.3 Ibs. (1.5 kg)
Drive Shaft Length ........................................................................................
26" (66 cm)
Cutting Width ...........................................................................................
1.5" (38 mm)
anag÷
Publicidad
