Publicidad
Idiomas disponibles
Idiomas disponibles
TO MOVE FORWARD
AND BACKWARD
The direction
and speed
of movement
is
controlled
by the forward and reverse drive
pedals.
1, Start
tractor
and
release
parking
brake,
2. Slowly depress forward(K)
or reverse(L)
drive pedal to begin movement,
Ground
speed
increases
the further
down the
pedal is depressed,
TO USE CRUISE
CONTROL
The cruise control feature can be used for
forward
travel only.
SYSTEM
CHARACTERISTICS
The cruise
control
should
only be used
while mowing
or transporting
on relatively
smooth, straight surfaces,
Other conditions
such as trimming at slow speeds maycause
the cruise control to disengage.
Do not use
the cruise control on slopes,
rough terrian
or while trimmimg
or turning.
• With forward
drive pedal depressed
to
desired
speed,
pull cruise control
lever
(J) up and hold while lifting your foot off
the pedal, then release the lever.
To disengage
the cruise control, depress the
brake pedal, tap on forward
drive pedal or
push the cruise control lever down.
TO ADJUST
MOWER
CUTTING
HEIGHT
The position
of the attachment
lift lever (A)
determines
the cutting height,
• Put attachment
lift lever in desired cutting
height slot.
• Slide
pointer
tab (T) to desired
cutting
height as a reminder for next timeyou mow.
The cutting height range is approximately
1" to 4". The heights are measured from the
groundtothebladetipwith the engine notrun-
ning.These heights areapproximate and may
vary depending upon soil conditions, height
of grass and types of grass being mowed.
• The average lawn should be cut to ap-
proximately 2-1/2" during the cool season
and to over 3" during hot months.
For
healthier and better looking lawns, mow
often and after moderate growth.
• For best cutting performance, grass over
6" in heightshould be mowed twice. Make
the first cut relatively high; the second to
desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properlyadjusted when
they are slightly offthe ground when mower
is at the desired cutting height in operating
position. Gauge wheels then keep the deck
in proper positionto help prevent scalping
in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on
a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CUTTING
HEIGHT" in this section of manual).
2. With mower in desired height of cut posi-
tion. gauge wheels should be assembled
so they are slightly off the ground, Install
gauge wheel inappropriate hole. Tighten
securely.
3. Repeat for all, installing gauge wheel in
same adjustment hole.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt bythe
operator to leave the seat with the engine
running and the attachment clutch engaged
wilt shut off the engine. You must remain
fully and centrally positioned in the seat to
preventthe enginefrom hesitating or cutting
offwhen operating your equipment on rough,
rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
16
Publicidad
