Miele Triflex HX1 Serie Instrucciones De Funcionamiento página 20

en-CA
Before charging the battery for the first
time, you must read the information in
"Installation and connection" –
"General battery information".
You will need a suitable location near a
free power socket for mounting the
appliance on the wall.
Wall mounting (Figs. 13 + 14)
The supplied wall bracket has a
mounting plate with a bag of screws
attached to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
 Remove the bag of screws.
 Press the release catch at the bottom
of the wall bracket (Fig. 13).
 Remove the mounting plate from the
wall bracket by sliding it downward
(Fig. 14).
Attaching the mounting plate
(Figs. 15 + 16)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling
diameter of 1/4" (6 mm)).
Depending on how you decide to
configure your vacuum cleaner, select a
distance of 17 3/4" (45 cm) or 38 9/16"
(98 cm) between the bottom edge of
the mounting plate and the floor (Fig.
15).
Be careful not to damage any cables
laid in the wall.
 Attach the mounting plate to the wall
(Fig. 16).
20
Attaching the charging cable to the
wall bracket (Figs. 17, 18 + 19)
A cable compartment is located on the
underside of the wall bracket.
 Press both release catches on the
underside of the wall bracket and
remove the cable compartment cover
(Fig. 17).
 Plug the supplied charging cable into
the opening from above (Fig. 18).
 Lay the charging cable in its guide
(Fig. 18).
 Refit the cover and lock the cable
compartment (Fig. 19).
Connecting the accessories holder
(if required) (Fig. 20)
An accessories holder is supplied for
storing the three-piece accessory set on
the wall bracket (see "Using the
accessories supplied").
 Push the accessories holder on to the
wall bracket as far as it will go.
Connecting the wall bracket
(Figs. 21 + 22)
 Slide the wall bracket down into the
mounting plate from above until it
audibly clicks into place (Fig. 21).
 Slide the PowerUnit of the fully
assembled vacuum cleaner, with the
battery inserted, down into the wall
bracket from above (Fig. 22).
 Plug the charger into the power
socket.
The charging process will start.