Elta RHC-4.6 Manual De Instrucciones página 14

BEFORE FIRST USE
Charge the device for 8 hours before using it for the first time.
- Make sure the product is turned off.
- Connect the charging cable to the product and then to the mains. The charge
indicator lights up.
- The hair clipper cannot be overloaded. However, if the product is not going to
be used for a long time (2-3 months), unplug the power cord from the wall
socket and store it. Fully charge the clipper when you want to use it again.
- To extend the life of your batteries, discharge them all six months and then
charge for 14-16 hours.
CHANGE ATTACHMENTS
- NOTE: Always make sure the hair clipper is switched off before changing
attachments.
-If you want to change an attachment, first bring it into the correct position with
your finger by aligning it with your body.
-Remove the attachment as shown. (Fig. 1-2)
- To insert, push the attachment onto the base in the direction of the lock.
(Fig. 3-4)
-Put the desired guide comb onto the base from above. (Fig. 5-6)
-There are four combs in four sizes (see table).
CHOOSE THE RIGHT COMBINATION
a
b
c
d
- Remove the comb from the bottom up. (Fig. 7-8)
- To remove the foil razor attachment, press the two sides and remove it from
the base. (Fig. 9)
- To insert the foil shaver attachment, press the two sides and insert it into the
base. (Fig. 10)
PRECISION COMB (f)
Level
1
2
3
4
Level Length (mm)
1
2
3
4
Length (mm)
4
4.5
5
5.5
3
6
9
12