Publicidad
Idiomas disponibles
Idiomas disponibles
Install the ADC-VDB750
Physical installation (New install or standard video doorbell replacement)
Note: If replacing an existing Slim Line (I/II) Doorbell Camera, see
replacement)
below for an alternative (optional) physical installation process that requires the ADC-VDB750 Backplate
Adapter (sold separately as ADC-VDBA-750-BPA).
1. Turn off power to the doorbell circuit (transformer). The recommended transformer rating is 16VAC 10VA.
2. Verify that the chime wire terminals are connected to one wire run from the transformer and one wire run from the
doorbell.
◦ If the in-home chime is mechanical (rather than digital), connect the Alarm.com International Video
Doorbell Power Module (sold separately as ADC-VDBA-PM-INT) to the chime by connecting the power
module's two white wires to the two terminals in the chime.
a. The exact terminals will vary by model, please reference the chime user manual. The terminals may
match where the existing wires are connected.
b. Although the correct two terminals for the chime model must be used, either white wire from the power
module can be connected to either target terminal on the chime.
c. Do not connect the black wires to any terminals (these should remain insulated and not in electrical
contact with any components) - this can result in damage to the hardware.
Note: Mechanical chimes are supported when using AC or DC power.
See below for wiring diagrams when installing the ADC-VDB750 to a mechanical chime with an AC
transformer and DC power supply, respectively:
AC transformer
DC power supply
◦ If there is no wired in-home chime, verify that the power source (AC or DC) meets the product requirements,
and wire directly (polarity does not matter) to the ADC-VDB750 (no in-line resistor is required).
Important: The Power Module should not be used with digital chimes.
3. Remove the existing doorbell from the wall and disconnect the wires. Secure the wires so that they can be
connected in a later step.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Alarm.com_Video_Doorbell_(ADC-VDB7...
Physical installation (Slim Line I/II
Updated: Wed, 07 Jun 2023 04:11:29 GMT
3
Publicidad
