Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION, PLEASE READ THESE INSTRUCTIONS CAREFULLY
and ensure that all users have been warned and
trained in the use of this electrical appliance.
1. GENERAL INFORMATION
Tesla is a coil that generates a small field of electromagnetic waves that pass through
the air and even travel through the air, capable of transferring its electrical energy
without the need for wires.
The base contains a high-frequency transformer. These waves excite the noble gas
inside the containers, causing them to glow with the fluorescent color of each gas.
The minimal differences in the space between the walls that the gas occupies and
the differences between the temperature of the two layers of the glass make the gas
glow in the form of a tree and when we touch the container we modify it with our
temperature and electrical charge, attracting the gas towards our fingers.
2. SPECIAL WARNINGS AND CARE
This chapter provides you with important safety notices when handling the device.
PLEASE NOTE: Read this User Manual and all safety notes carefully before using
the machine for the first time. We advise you to keep it for future inquiries.
1.
Do not modify any connections or external elements, or open the appliance, as
this will void the warranty.
2.
Do not place metallic or flammable elements on its surface.
3.
Keep this equipment out of reach of individuals who have not been informed of
these precautions.
4.
Do not touch the surface with your hands while carrying out any manipulation or
attempting to connect it to the mains on wet surfaces.
5.
The lower part can become very hot if left on for a long time, so handle it with care.
6.
The Tesla Kit is not a toy. It is professional equipment intended for use by trained
personnel only.
7.
Do not enclose this device in a sealed box without ventilation, as it could overheat
and cause a short circuit.
8.
Do not operate this product on heat-sensitive surfaces.
9.
Compact and safe. Does not cause electric shocks, only an electromagnetic field.
2
2
Tesla Bar&Cocktail©2024 · User's Manual · V2· ENGLISH
1.
Before starting, remove the protective plastic film from the surface.
2.
Charge the base until the charger light turns green.
3.
Only turn on the unit when you are going to perform the drink service.
4.
Leave the unit on for a maximum of 6 minutes, as the plate heats up and for safety
may block the service.
5.
If left on, the consumption and heating will be the same, so remember to turn off
the switch once the service is completed.
6.
The batteries have a safety temperature control that, if they exceed 50°C, will
become locked for use and will not work again until they drop back down to 30°C.
To accelerate this process, it is recommended to leave the unit in a lateral position
to help dissipate the heat, or place it in a refrigerator or freezer for approximately
5 minutes.
7.
After each service, turn off the switch and plug it back into the charger. With
this system, you can extend the use of your equipment for more than 30 times
without any problem.
8.
The space dedicated for charging must be ventilated and away from heat sources.
Place the device in a lateral position whenever possible to accelerate its cooling.
9.
Do not place two operating bases together, as they will generate a superior field
that will accelerate the heating of the plates.
10. If you need to perform a very active and repetitive service, it is recommended to
have more bases available so that you can have some in cold storage and always
have free bases.
ATTENTION, PLEASE READ THESE INSTRUCTIONS CAREFULLY
and ensure that all users have been warned and
trained in the use of this electrical appliance.
Tesla Bar&Cocktail©2024 · User's Manual · V2· ENGLISH
3
Publicidad
