Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
personal injuries, read and follow all important safety
warning and instructions before using this tool.
WARNING:
is switched off before insertion or removal of the battery
pack.
INSTALLING OR REMOVING THE
BATTERY PACK (FIG 2)
• to install the battery pack, slide the battery pack into
the bottom of the tool housing all the way until it locks
in place with a click, as shown in fig 2. lightly pull on
the battery to ensure it is locked into place and will not
accidentally fall out of the tool, causing an injury.
• to remove the battery pack, pull the battery pack away
from the tool while depressing the battery locking tab
(7).
7
CHARGING THE BATTERY (FIG 3)
NOTE:
always check that the power supply corresponds
to the voltage on the ratings plate.
• Plug the charger (11) into a 120 Volt aC power source.
the green indicator light on the charger will illuminate,
confirming it is powered.
• Connect the charger to the battery (10) as shown in
fig 3. the red light on the charger will illuminate,
indicating that the battery is charging. Meanwhile, the
power indicator lights (8) on the battery pack will flash,
indicating the charging status.
• all three indicate lights will turn solid green once
charging is complete.
• it is normal for the battery pack to become warm while
charging.
• if the battery pack is hot after continuous use in the
tool, allow it to cool down to room temperature before
charging. this will extend the life of your batteries.
NOTE:
it takes approximately 80 minutes to charge up
a completely discharged 2.0ah battery pack.
OPERATION
to reduce the risk of serious
always be sure that the tool
FIG 2
8b
8a
10
BATTERY POWER INDICATOR (FIG 3)
there is a battery power indictor on the battery pack. it
has three green lights (8b). Depress the power indicator
button (8a) on the side to check the battery power level.
when all three lights illuminate, it indicates the battery is at
full power. the battery is at half full power when two lights
illuminate. when one light illuminates only, it indicates that
the battery is at low power level and requires immediate
charging.
WARNING:
battery pack from the tool or place the switch in the
locked or off position before any assembly, adjustments
or changing accessories.
TRIGGER SWITCH ACTION (FIG 4)
• turn the drill on by depressing the trigger switch (4).
• Depressing the switch further will produce more speed
and torque.
• use the reversing switch (5) to change the direction of
rotation of the drill.
• the reversing switch has three positions: forward,
reverse, and off (middle).
• always check the rotation before beginning your work.
4
TWO-SPEED GEAR SWITCH (FIG 4)
• slide the speed gear switch (2) to choose between
position 1 for high-speed range (0-1500 rPM) and
position 2 for low-speed range (0-380 rPM).
• the low-speed range has more power and torque.
use the low-speed range for high-power and torque
applications.
• the high-speed range is for fast drilling or driving
applications.
ENGLISH
FIG 3
always disconnect the
2
5
FIG 4
11
7
Publicidad
