SHOWJOE 24V-X2-SB18 Manual Del Operador página 12

Fig. 7
Middle frame
Discharge Chute Assembly
1. Loosen the chute deflector knob to lift the chute deflector
(Fig. 8).
Fig. 8
Chute deflector knob
Chute
deflector
2. Lift the chute deflector and lock it securely onto the
discharge chute (Fig. 9).
Fig. 9
Chute
deflector
3. Raise or lower the chute deflector to the desired height of
the snow stream and tighten the chute deflector knob
(Fig. 9).
NOTE: Do not overtighten the chute deflector knob.
Upper
frame
Knob +
T-bolt
Chute
deflector
knob
Chute Crank Assembly
1. Slide the upper chute crank through the rubber ring 1.
Remove the hitch pin from the female end of the lower chute
crank (Fig. 10).
Fig. 10
Lower chute crank
(female end)
2. Install the lower crank rod by inserting it into the opening at
the back of the housing and aligning the holes (Fig. 11).
Fig. 11
Align the holes
3. Secure the lower chute crank in place with the hitch pin (Fig. 12).
Fig. 12
4. Remove the other hitch pin from the lower chute crank (Fig. 13).
Fig. 13
Lower chute
crank
12
Hitch Pin
Lower chute crank
Hitch pin
Hitch Pin