Pioneer PDP-S21-LR Manual De Instrucciones página 5

2. For the output terminals on the plasma display, push the lever,
insert the cable into the hole, and release the lever.
ª · · ª
R L
÷ After connection to the terminals, pull lightly on the cable
to confirm that the tips of the cable are properly connected
to the terminals. An imperfect connection can cause
sound interruptions and noise.
÷ When cable cores stick out and ª and · lines are short-
circuited, an excessive load will be applied to the plasma
display and the operation will stop or trouble will be
caused.
2 How to route cables
Speed clamps are included with the plasma display for tidying your cables and keeping extra cable length out of the way.
When installing the speakers on the right and left sides of the display
Speaker cable
When installing the speakers at the bottom of the display
Speaker cable
Output terminal of plasma
display
Wiring clamp
Wiring clamp
÷ When the polarity is reversed for one speaker (left or right)
at the time of connection to the plasma display, the bass
reproduction will be reduced, the sound positioning will
be lost, and a correct stereo effect will not be obtained.
÷ If you insert the speaker cord too far so that the insulation
is touching the speaker terminal, you may not get any
sound.
< right >
Speed clamps Speaker cable
A speaker cable or system cable is put in
the rack using a supplied wiring clamp so
that it cannot be viewed from the front.
Speaker cable
English
< wrong >
5