Amann Girrbach steamer X3 Modo De Empleo página 19

5 Installation
NOTE:
Danger of heat accumulation!
During operation, the Steamer X3 disperses
heat.
▷ Do not mount the Steamer X3 into a cabinet
or enclosure.
The Steamer X3 can be set up on a table or wall-
mounted.
▷ For installation, please observe the clearances
in lateral and upward direction.
There are no clearance requirements to be
observed toward the rear and bottom of the
machine.
≥ 5 cm
Fig. 2 Clearances
▷ Select the installation location ensuring that a
socket outlet is close by.
The length of the mains cable is 2.5 m.
5.1
▷ Set up the machine on a work table or work-
bench.
▷ Set the machine's main switch (on left side) to
the 0.
▷ Insert the mains cable to the socket on left side
of the machine and the plug into a socket outlet.
5.2
A drilling template has been provided for mount-
ing to the wall, and enables swift and precise local-
isation of the drill holes to the wall. The wall must
be sturdy enough to carry the weight of the
machine.
▷ Place the the drilling template at the desired
position.
≥ 10 cm
▷ Mark the 4 drilling locations, remove the drilling
template and drill the holes to the correct dowel
size.
▷ Insert dowels suitable for the wall structure into
the drill holes.
▷ Screw 4 screws into the dowels leaving the
screw heads clear by approx. 6 mm.
▷ Attach the machine to the four protruding
screw heads.
▷ Set the machine's main switch (on left side) to
the 0.
▷ Insert the mains cable to the socket on left side
of the machine and the plug into a socket outlet.
I N S T A L L A T I O N
Set up on a table
Mounting to a wall
For damage resulting from improper wall
mounting, the manufacturer shall exclude
any liability whatsoever.
The drilling template must be accurately
levelled.
▷ Check the alignment with a spirit level.
E N
19