Derungs Dmed Triango 100 C Instrucciones De Montaje Y Funcionamiento página 26

ENG

Insert the arm for wall-mounting 3 into wall bracket 1
slightly

Insert the sliding piece 2 into the groove

Push up the arm 3 in such a way that the hole in the wall
bracket is aligned with the hole in the sliding piece

Screw grub screw 4 into wall bracket

In the case of a dead stop, screw this back by a ¼ turn
and check the turning function

Continue with luminaire head assembly, see Chap.6
5. INSTALLATION: Triango 100 F
►
Remove the M3 screws on the sides and remove the
power supply tray "A".
26
A
►
Loosen the 2 screws on the lower support tube.
►
Feed the support tube cable through the roller stand.
►
Attach the support tube to the roller stand using the 2
Allen screws and serrated washers (10 Nm).
►
The cable holder must be aligned rearward.
►
Connect the same-colored stranded wires of the lower
support tube and of the power supply.
►
Reinstall the power supply tray with the M3 Allen screws
and serrated washers.

Loosen the grub screw 1

Place the spring balanced arm 2 on the upper support
tube

Attention: Grub screw 1 must be inserted into slot 3.

Screw in the grub screw in the alignment shown

In the case of a grub screw dead stop, screw this back
by a ¼ turn and check the turning function (Swing range
± 30°)
2
1
3
°
± 30