Eaton TRIPP-LITE CSD32USB Manual Del Propietário página 8

7. Desktop Placement
14"
TOP
355.6 mm
2"
50.8 mm
2 13/16"
A
17.56 mm
WARNING: For desktop applications, always install the charging station in a structurally
sound area with a level surface that is able to bear the weight of the charging station, all
equipment that will be installed in the charging station and any other enclosures and/or
equipment that will be installed nearby. Never attempt to lift or install the charging station
without adequate help. See Section 8. Specifications for more information on the
charging station's rated load capacity.
For an added measure of security, the cabinet can secure to a desktop. There are two
keyhole cutouts located at the rear end of the bottom panel. Each keyhole can
accommodate an M5 or 3/16" bolt. The bottom keyhole set is centered 18" (457 mm)
apart horizontally and 14" (356 mm) vertically from the front mounting holes
Using a tape measure, measure to position your mounting areas precisely. Use
appropriate fasteners (not included) to attach the cabinet to the rear keyhole cutouts
and secure the charging station to the desktop with the front mounting holes
Stacking Charging Station Cabinets
One charging station can be securely stacked onto another. First remove the bottom shelf from inside the cabinet that will be placed
on top . Carefully place the top cabinet on top of the bottom cabinet, aligning the top cabinet's front mounting holes and rear keyhole
A
cutouts with the bottom cabinet's threaded inserts located on the top panel
screws (not included) .
C
A
Caution! Do not stack more than one Charging Station Cabinet.
Personal or property damage may result.
355.6 mm
FRONT
18"
457.2 mm 17.56 mm
8
14"
2"
50.8 mm
2 13/16" 18"
457.2 mm
.
A
B
.
C
. To secure the two cabinets, use four (4) M6 x 20 mm
B
B
BOTTOM
FRONT
B
C
C
C
C
C
B
C