Taurus BOREAL SILENCE Instrucciones De Uso página 9

EN English (Original instructions)
STAND FAN
BOREAL SILENCE
DESCRIPTION
A Front Grill
B Propeller nut
C Propeller
D Grill Nut
E Rear Grill
F Motor Shaft
G Motor Housing
H Supply Cord
I Upper lock nut
J Lower lock clamp
K Control panel
L Inner Pipe
M Base Pipe
N Base
O Base Screw
P Fixing belt
Control Panel (K)
1 ON/Speed Change button
2 Timer button
3 Swing button
4 Off button
5 Fan Working Indicator
6 Timer Indicator
7 Oscillation Indicator
8 Mode Indicators
8.1 Normal Mode Indicator
8.2 Breeze Mode Indicator
8.3 Night Mode Indicator
Remote Control
a Off button
b Swing button
c Timer button
d Mode button
e On/Speed change button
USE AND CARE
• Fully extend the appliance's supply cord before each use.
• Do not use the appliance if the on/off buttons do not work.
• Do not use the appliance if the speed selection buttons
do not work.
• Do not move the appliance while in use.
• Do not use the appliance if it is tipped up and do not turn
it over.
• Do not turn the appliance over while it is in use or
connected to the mains.
• Disconnect the appliance from the mains when not in use
and before undertaking any cleaning task.
• Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
• Keep the appliance in a dry, dust-free place, out of direct
sunlight.
• Make sure that dust, dirt or other foreign objects do not
block the fan grill on the appliance.
• Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
• Never leave the appliance connected and unattended if
is not in use. This saves energy and prolongs the life of
the appliance.
• Do not use the appliance to dry pets or animals.
• Do not use the appliance to dry textiles of any kind.
INSTALLATION
• Be sure to remove all packaging material from inside the
appliance.
• Ensure that the fan is switched off from the supply mains
before start any installation or assembly operation.
• Do not remove the support base of the appliance.
• Ensure that the appliance is level with respect to the floor.
• Do not cover or obstruct the sides of the appliance
and leave a minimum space of 40cm front other walls,
ceiling...
• The plug must be easily accessible so it can be
disconnected in an emergency.
• The appliance should be used with its base fitted.
ASSEMBLING THE BATTERY/S
• This appliance uses a pair of 1,5V AAA batteries.
• Caution: During the handling of batteries, do not touch
both poles at the same time, as this will provoke the