Taurus HOMELAND ULTIMATE DIGITAL Instrucciones De Uso página 12

• Attach the water tank to the floor brush, using the
connectors, until you hear a click. (Fig. 4).
• Operate the appliance as usual; water will flow out,
wetting the mop and cleaning the floor.
• Once you finish mopping, proceed with the cleaning steps
explained in the «Cleaning» section.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Turn the appliance off using the on/off button.
• Remove the battery from the appliance if you are not
intending to use the appliance during an extended period.
• Clean the appliance.
PARKING POSITION
• This appliance has its own parking position for
comfortable and straightforward storage.
SAFETY THERMAL PROTECTOR
• The appliance has a safety device, which protects the
appliance from overheating.
• If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
• Disconnect the battery charger from the mains and allow
it to cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
• Never immerse the appliance in water or any other liquid
or place it under running water.
EMPTYING THE DUST TANK
• Empty the dust tank when it is full (observation facilitated
by transparent tank), when vacuuming power is notably
reduced, or when dust tank full indicator (6) is on.
• Disconnect the tube from the dust tank.
• Disconnect the dust tank from the appliance. (Fig. 2).
• Open the dust tank lid by pressing the release dust button
(I) and empty the contents into the appropriate waste
disposal receptacle.
• Check the condition of the filter and clean it or replace it if
it's necessary.
CHANGING THE FILTERS
• Dust tank filter (HEPA) (high efficiency air filter that
efficiently retains spores, ash, sawdust, pollen...), it is
advisable to change it a least once a year or after every
50 hours of use, or if its potency diminishes remarkably.
TO REMOVE THE FILTERS
• Remove the dust tank by pressing the tank removal lock
lever (H) and turning it clockwise, as indicated by the
arrow and the padlocks.
• HEPA filter can be taken put pulling it outwards.
• Extract the cyclone by pulling it outwards.
• Clean the filter or replace it if necessary with clean water
and let ir air dry. (Fig. 3).
• To reassemble the filter, proceed with the above
instructions, in reverse order.
CLEANING THE FLOOR BRUSH
• To remove the roller brush, at the side of the shoe, move
the tab towards the open padlock and unhook (Fig.5) the
side piece that fixes the roller brush and releases it.
• Remove the roller brush and clean.
• To reassemble the roller brush, follow the above
instructions in reverse order.
CLEANING THE MOP (*)
• Once moping usage is finish, remove the mop by pulling
it outwards.
• Rinse the mop with clear water and soap or, if desired,
you can wash it in the washing machine.
• Allow to air dry.
• To reassemble the mop, follow the above instructions but
in reverse order.
SUPPLIES
• Supplies can be acquired from distributors and authorised
establishments (such as filters, etc...) for your appliance
model.
• Always use original supplies, designed specifically for
your appliance model.
• These supplies are available in specialist shops.
• The type reference of the battery pack for this appliance
is 3020E296YNK-XXX.