Costway JL10029DE Manual Del Usuario página 6

Solution of ordinary malfunctions
▪ It is natural movement voice if the motor sounds while in
usage.
▪ If the controller can't work normally, please check the plug
and socket if they are connected strongly and make sure
the switch is turned on.
▪ If the rated working time is over, the product will
automatically activate the power-off button; If this product
works continuously for long, the temperature protector will
make the product automatically power-off, it should be
used again after half an hour's rest.
Parts installation
Calf installation
1.Insert the wires and tubes of the calf into the sockets at the front of
the steel frame assembly respectively (Figure 1).
2.Then push the connected wire and tube into the hole of the backrest
frame (Fig. 2).
3.After the wire butt joint is completed, open the fixing covers of the
calf part on both sides of the steel frame assembly (Figure 3).
4.Lift the calf part, put it into the notch, and cover the fixed cover, and
finally fix it in place with 2 screws (Figure 4).
Note: This step can be ignored for the model of integral installation.
10
Placement of massage chair
Make sure there is enough room so that the massage chair can recline
by at least 24.2cm(9.5 inches).
Do not expose the massage chair to direct sunlight and high
temperature environments (such as: in front of heating equipment).
The location should avoid high temperature and direct sunlight. If it is
used in a designated location for a long time, it is recommended to lay
soft mat on the ground. When laying the mat flat, the size of the mat
should be large enough to cover both the area where the machine
touches the floor and the area where your feet touch the floor.
11