Aqara H2 EU Manual De Instrucciones página 4

Installation introduction
Pre-installation instructions:
* Please disconnect the main power switch at home before installation
* Please prepare a Phillips screwdriver before installation
* Please ensure that the depth of the socket box where the socket is
installed is at least 50mm
Installation steps:
Remove the other sockets used first and mark the Live wire, Null wire
1
and Ground wire in the wires in advance.
Open the socket package and take out the socket H2 and screw
2
accessories in the package.
Use a cross screwdriver to loosen the screw in the center of socket H2,
3
and remove the decorative cover, middle frame of socket H2
respectively.
Connect the Live wire, Ground wire and Null wire to the L, ,N power
4
interface on socket H2 in sequence, and tighten the fastening screws
of the power interface.
Use the screw accessories in the package to fix the socket to the screw
5
hole post on the box.
6
Install the middle frame and decorative cover in sequence,and fix the
above components with screws to complete the installation.
02