Goldstar BG8000ER Manual Del Propietário página 14

Installation
Unit Installation
Caution: During the following step, hold unit firmly until window sash
is lowered to top channel behind side panel frames. Personal injury or
property damage may result if unit falls from window.
1. Open the window. Mark a line on
center of the window stool(or desired
air conditioner location).
Carefully place the cabinet on the
window stool and align the center
mark on the bottom front with the
center line marked in the window
stool.
2. Pull the bottom window sash down
behind the upper guide until it meets.
:Do not pull the window sash
Tip!
down so tightly that the movement of
Frame Curtain is restricted.
3. Loosely assemble the sill support
using the parts in Figure 3.
4. Select the position that will place the
sill support near the outer most point
on sill (See Figure 4)
: Be careful when you install
Tip!
the cabinet (Frame Guides will be
broken easily).
5. Attach the sill support to the cabinet
track hole in relation to the selected
position using 2 Type A screws in
each support(See Figure 4).
6. The cabinet should be installed with a
very slight tilt(about
toward the outside (See Figure 5).
Adjust the bolt and the nut of sill
support for balancing the cabinet.
7. Attach the cabinet to the window stool
by driving the screws (Type B:Length
sixteen millimeters and below.) through
the front angle into window stool.
8. Pull each Frame curtain fully to each
window sash track, and repeat step 2.
14 Room Air Conditioner
INDOOR
/ ") downward
1
2
Upper Guide
Window Sash
Foam-Pe
Cabinet
Frame Curtain
Foam-Pe
Bolt
Frame Guide
INDOOR
Screw(Type B)
Screw(Type B)
Sill Support
Window Stool
Front Angle Figure 1
Upper Guide
Figure 2
OUTDOOR
Sill Support
Nut Figure 3
Screw(Type A)
Cabinet
OUTDOOR
Figure 4
Sill Support
Sash Track
Front Angle
Figure 5