Publicidad
Idiomas disponibles
Idiomas disponibles
Do use the cutting wheel which edge has been minded very
sharp. The hands and body can't approach the rotating
cutting wheel too near, and of course can't touch the
rotating cutting wheel. Do close the current source when
disassembling, draw out the plug, and please don't make
such operation until the cutting wheel stops completely.
If needing to clamp the object or changing the position and
angle of the project, please wait for the tool stops and then
make above-said operations.
The temperature is very high of project part that is just cut
off don't touch it to avoid scald.
It will decrease the hardness of the cutting wheel if storing
it in moist place, please store it in drying place when not
use it, lay it in level to avoid distortion.
Don't damage the axel, pressure board and bolts of the
machine, or it will damage the cutting wheel during the
course of assembling it.
Don't move the protective shield of cutting wheel because
of minding troubles or lock the safety protective equipment.
It's limited to use the pressure plate attached in the
machine.
When pressing the work piece, firstly push forward the
handle until the vice jaw reaches the work piece, then press
the fast nut downwards and turn the handle clockwise to
fix the work piece (picture 6).
When the cutting wheel is worn out greatly, put a non-
flammable hard cushion under the back of the work piece,
thus it can use the middle edge of the cutting wheel to cut
the object efficiently. Only when cutting small object and
the object can be fully clamping may the cushion be used
in this manner.
Do not force the power tool.
Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for
which it was designed.
Do not use the power tool if the switch does not turn it on
and off. Any power tool that cannot be controlled with the
switch is dangerous and must be repaired. Disconnect the
plug from the power source before making any adjustment,
changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting
the power tool accidentally. Store id ie power tools out of
the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the
power tool. Power tools are dangerous in the hands of
untrained users.
Maintain power tools.
Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect
the power tools operation. If damaged, have the power tool
repaired before use.
Many accidents are caused by poorly maintained power
tools. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control. Use the power tool,
accessories and tool bits etc., in accordance with these
instructions and in the manner intended for particular type
of power tool, taking into the switch trigger again is OK
(picture 7).
A - Locking button
B - Switch trigger
Publicidad
