Descargar Imprimir esta página

Parkside 385580 2107 Traduccion Del Manual De Instrucciones Originale página 17

Amoladora angular recargable

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 140
Adjusting the blade guard
WARNING! RISK OF INJURY!
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
RISK OF INJURY!
Always use the angle grinder with the blade
guard
. The blade guard should be
installed securely. Set it so that the highest
possible degree of safety is achieved, i.e.
the smallest possible part of the grinding
disc is exposed to the operator. The blade
guard
is designed to protect the operator
from fragments and accidental contact with
the grinding tool.
Make sure that the blade guard
at at least the same angle as the additional
handle
(see fig. B). Otherwise, you could
injure yourself on the roughing disc or cutting
disc.
Turn the blade guard
(working position). Make sure that the blade
guard
is positioned in such a way that the
blade guard fixture
5 bulges
on the blade guard
(fold-out page).
Ensure that the blade guard fixture
seated in the respective bulge
Fitting the additional handle
CAUTION!
For safety reasons, this appliance may only
be used with the additional handle
Failure to do so can lead to serious injury.
The additional handle
onto the left, the right or the top, depending
on the job at hand.
GB │ IE
12 
is fitted
to the required position
lies over one of the
(see Fig. E
is firmly
.
.
can be screwed
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when
changing cutting/rough grinding discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
attachment flange
without any play. Do not use
a reducer or adapter.
NOTE
Use only discs which are free of dirt.
Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
RISK OF INJURY! Press the spindle locking
button
only when the attachment spindle
is at a complete standstill.
Press the spindle locking button
motor.
Undo the clamping nut
mounting spanner
Place the rough grinding or cutting disc with the
label side towards the appliance on the attach-
ment flange
.
Then replace the clamping nut
ment spindle
with the raised side facing up.
With thin grinding discs (see fig. 1)
The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
Press the spindle locking button
motor.
Tighten the clamping nut
mounting spanner
to lock the
using the two-hole
(see fig D).
on the attach-
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
PWSA 20-Li C3
12

Publicidad

loading

Este manual también es adecuado para:

Pwsa 20-li c3