Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Push connection piece over the tails and tighten
with nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single hole mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 5a) located behind the mousseur must
be removed.
To simplify installation pressure hoses no.
13098000 are available.
English
Spare parts
1
2
3
4
5
6
7
7.1 pull knob
7.2 pull rod
8
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
knob for cold water
knob for hot water
spout
washer
mousseur cpl.
mousseur gold
ELASTOP stop unit
pull rod cpl.
fixation cpl.
15291XXX
15292XXX
95035XXX
92646000
13085000
94980990
94149000
92620XXX
94066XXX
94067000
94701000
Publicidad
