Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver's cut¬
ting performance.
Replacing the system outer foil
(see fig. 7)
Squeeze the system outer foil re¬
lease buttons and lift the system
outer foil upward to remove it. To in¬
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but¬
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
ATTENTION: The product you
have purchased is powered by a
nickel cadmium battery which is re¬
cyclable. At the end of it's useful
life, under various state and local
laws, it is illegal to dispose of this
battery into your municipal waste
stream. Please call 1-800-8-BAT¬
TERY for information on how to
recycle this battery._
How to remove the built-in re¬
chargeable battery
(see fig. 9)
The procedure described below is in¬
tended only for removal of the re¬
chargeable battery for the purpose
of proper disposal.
WARNING: Do not attempt to re¬
place the built-in, rechargeable
batteries yourself for the purpose
of reusing the shaver. This could
result in the risk of fire or electric
shock. Please contact your near¬
est authorized Panasonic service
center.
1. Remove the cap, outer foil frame
and inner blades.
2. Remove the two parts (a), (b) and
two screws (c).
3. Remove two screws (d) and bot¬
tom cover (e).
4. Push the chassis out of the hous-
ing.
5. Remove the batteries from the
chassis.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE3-80 to charge
the ES7003/ES7002 shaver.
• The supply cord of the charging
8
Publicidad
