Husqvarna LF 50 Manual Del Usuario página 12

1. Apply full throttle.
2. Carefully push the product forward.
CAUTION:
down. Too much pressure can cause
unsatisfactory result.
3. To change direction, turn the product around.
a) To turn the product with a minimum turning
radius, lift the handle to a 90 degrees angle. Use
this function in small spaces and on ground that
is not level.
To set the LF 50 in operation position
1. Loosen the handle knobs (A).
B
A
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
12
Do not push the product
Maintenance
Read and understand the
2. Lift the handle (B).
3. Tighten the handle knobs (A).
To set the LF 50 in transport position
1. Loosen the handle knobs (A).
A
2. Lower the handle (B).
3. Tighten the handle knobs (A).
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
B
1107 - 008 - 02.05.2024