Elektrobock ELBO-073 Manual Del Usuario página 9

A wireless pool alarm is an electronic monitoring device that detects children or animals falling into the pool, as
well as visits from unwanted people. The transmitter will automatically trigger the wireless siren once a detection
of any event with suffi ciently large waves is generated.
The pool alarm system consists of 2 parts:
• The transmitter, which fl oats on the pool surface, is
powered by a CR123 battery and is tied to the edge
in a suitable location.
transmitter
(sensor)
Installation: Installation:
The sensor is fully functional from the factory. You just need to remove the insulating paper from the battery and
place the sensor on the water surface. Then connect the receiver to a power outlet.
Activation:
Briefl y press the push button on the transmitter for 1 s, a long tone will sound. Release it and place it on the calm
pool surface. If the sensor does not detect any movement for up to 1 minute, it activates; this is indicated by
beeps and short light pulses for each 5 s. From this moment on, the alarm system is active and guards the pool
surface.
The button on the back of the receiver is for pairing only.
Press the button
Switching off:
by pressing the button on the front side for 3 seconds or longer (switching off is accompanied by two short,
intermittent beeps).
If the transmitter detects surface movement, you have 5 s to switch off the transmitter (see above) so that no
alarm is triggered. This time is displayed with beeps.
Pairing:
The transmitter is paired to the siren at the factory. You can check this by inserting the siren into the socket and
triggering the alarm using the transmitter. If the siren doesn't respond, pair the set again.
• Press (approx. 1.5 s) the button on the back of
the siren.
• The diode starts fl ashing and the receiver is
ready to pair.
• Trigger an alarm using the transmitter.
• If you are unsuccessful, repeat the process.
• Receiver, is connected to a 230 V AC socket and can
be up to 300 m away from the transmitter.
Range in the building 30 m
Range in an open area 300 m
1 min
Display of the status of the siren using an LED
diode:
Flashes 1x/2 s: empty memory
Flashes 1x/1 s: learning mode
Flashes 1x/0.5 s: weak battery in the transmitter
Lit: paired
9 | Češti na 9 | English
Receiver
(siren)
ACTIVE