Publicidad
8
500 SERIES PARAMETRIC EQUALISER 512
500 SERIES PARAMETRIC EQUALISER 512 Controls
(2)
(3)
(6)
(7)
(9)
(10)
(12)
(13)
(15)
(1)
(4)
(5)
(8)
(11)
(14)
(16)
Mounting holes - The 512 module is
(1)
mounted to the host 500 series rack
chassis or box such as the Midas Legend L6
or L10, and secured using two screws top
and bottom.
Treble frequency control - This control
(2)
(outer knob) gives continuous adjustment
of the frequency range from 1 kHz to 20 kHz.
Treble gain - This control (inner knob)
(3)
gives continuous adjustment of treble cut
and boost from -15 dB to +15 dB with a
0 dB centre detent.
BELL switch - When this is selected,
(4)
the treble equaliser curve changes from
the traditional Midas shelving response to
fully parametric operation. The switch's
green LED illuminates to show that the
BELL mode is active.
Treble width control - This knob gives
(5)
continuous control of the bandwidth from
0.1 to 2 octaves. It only operates when the
BELL switch is selected.
Hi mid frequency control - This control
(6)
(outer knob) gives continuous adjustment of
the frequency range from 400 Hz to 8 kHz.
Hi mid gain - This control (inner knob)
(7)
gives continuous adjustment of cut and
boost from -15 dB to +15 dB with a 0 dB
centre detent.
Hi mid width control - This knob gives
(8)
continuous control of the bandwidth from
0.1 to 2 octaves.
Lo mid frequency control - This control
(9)
(outer knob) gives continuous adjustment
of the frequency range from 100 Hz to 2 kHz.
Lo mid gain control - This control
(10)
(inner knob) gives continuous adjustment
of cut and boost from -15 dB to +15 dB
with a 0 dB centre detent.
9
Quick Start Guide
Lo mid width control - This knob gives
(11)
continuous control of the bandwidth from
0.1 to 2 octaves.
Bass frequency control - This control
(12)
(outer knob) gives continuous adjustment
of the frequency range from 20 Hz to
400 Hz.
Bass gain control - This control
(13)
(inner knob) gives continuous adjustment
of cut and boost from -15 dB to +15 dB
with a 0 dB centre detent.
BELL switch - When this is selected,
(14)
the bass equaliser curve changes from the
traditional Midas shelving response to
fully parametric operation. The switch's
red LED illuminates to show that the BELL
mode is active.
Equaliser IN switch - This switch
(15)
inserts the equaliser into the signal path.
The switch's yellow LED illuminates to
show that the equaliser is active. When the
IN switch is deselected, all the circuitry is
completely bypassed (true relay hardware
bypass). True bypass mode also occurs
if the 500 series rack is powered down,
as the signal passes directly from the rack
input XLR to the rack output XLR.
Bass width control - This knob gives
(16)
continuous control of the bandwidth from
0.1 to 2 octaves. It only operates when the
BELL switch is selected.
Publicidad
