Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1: Set the Power Switch to Off
Make sure the power is switched off on the HP
Surge Protector.
STEP 2: Testing the HP Surge Protector
Plug your HP Surge Protector directly into a properly
grounded 3-wire AC outlet. Turn the switch on to test
the unit. If the green "PROTECTION ON" light is
illuminated, then the surge protector is on. Switch off
the surge protector before proceeding to Step 3.
NOTE: If the "GROUND OK" light does not illuminate,
contact a qualified electrician.
STEP 3: Plugging in Your Components
• V erify the surge protector is switched to the OFF
position before proceeding.
Publicidad
