BEA KMR AN34/60-642E Instrucciones De Uso Específicas página 7

Device-specific additional instructions for nailer
4 Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.

Check fasteners for proper condition.

Put nailer carefully down in defined safe resting position (Chap. 3):
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection.

Put nailer carefully down in defined safe resting position (Chap. 3):
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection
5 Adjusting drive-in depth
Mechanical adjustment of drive-in depth:

Turn adjustment knob 1 for deeper countersunk nails clockwise.
Turn anti-clockwise to lower the nails less deeply.
6 Hole finding in the wood connector

Position
the tip of the tool in the hole of the wood connector. Press down
and trigger the tool.
7 EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
Date: 25.01.2023
------------------------------------------
Dr. Jörg Dalhöfer, CEO
AN34/60 - G642E
.
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7