Publicidad
Idiomas disponibles
Idiomas disponibles
Screw all legs into the
5
threaded inserts. HAND
TIGHTEN.
min
max
height
height
3"
12"
Stack leg
segments and
screw ends
together to
adjust height
of base.
7
Flip base onto legs.
Operate remote control to test base
10
functions. See Remote Control User
Guide for programming instructions.
Insert the small side mattress retainers (2) into the holes at both sides of the
12
head section of the base. Insert the large mattress retainer into the holes at
the foot section of the base.
CUSTOMER SERVICE toll free: (800) 888-3078
NOTE
MAKE SURE ALL LEGS ARE AT THE SAME HEIGHT AND
LEG SEGMENTS ARE FULLY TIGHTENED TOGETHER.
TEAM
LIFT
FOOT
HEAD
If leg is
adjustable,
push pin in
to adjust leg
height.
Install batteries in remote
8
control, if applicable.
11
Lower base to flat
position.
Your base may be equipped with USB ports on each side of the base
(at the head end). These USB ports are for charging low-voltage
devices such as cell phones and tablets directly from the base.
USB ports are for charging convenience only. Remove USB charging
cord and/or power cord from USB charging station before entering
or exiting base. If an extended charging period is needed, it is
recommended to use the wall outlet.
USE THE DEVICE MANUFACTURER RECOMMENDED CHARGING
CABLE TO CHARGE THE DEVICE. USING UNAPPROVED CHARGING
Extend power cord out head end of base. Remove
6
protective covering from power cord plug.
Plug power cord
9
into power outlet.
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
USB PORTS
!
WARNING
CABLES IS A FIRE HAZARD.
291-0106-A EDR 17267 11/23
© 2023 Leggett & Platt, Inc. Adjustable Bed Group
FOOT
HEAD
NOTE
Publicidad
