humble One Smart Instrucciones De Uso página 4

EN
Product information Humble One S:
The Humble One S is a wireless lamp, available in multiple finishes, with a built-in
rechargeable battery. The light source is a 3V 1W LED filament bulb emitting 2200K (warm
white) light. A fully charged lamp remains lit for at least 24 hours (at full brightness) but can
last up to 140 hours (at the lowest brightness).
WARNING: READ CAREFULLY BEFORE USE!
Place the lamp on a dry, horizontal surface. Do not expose the lamp to excessive heat. The
lamp is intended for indoor use, but can be used outdoors. Protect it against water and
store inside after use. Check the voltage of your power supply; the voltage must be between
100 and 240V AC. Check the cable on the adapter provided for damage. When the lamp is
switched on, do not stare at the light source at full brightness, as this may cause eye damage.
The lamp is not a toy: keep away from children.
Instructions for use
The Humble One S operates on the Zigbee 3.0 protocol, making it connectable to most smart
home systems that work with a hub/bridge. Below and at humblelights.com/smart you will
find more information and explanations on how to connect to your smart home system, or
scan the QR code on page 2.
Connecting to Philips Hue & Tuya: Make sure the bulb is charged and turn the bulb on using
the on-off button on the bottom of the lamp. When you turn on a Humble One S for the first
time it will automatically be in pairing mode for 3 minutes. The lamp will pulsate to indicate
this. It can now be 'found' by your Hue/Tuya system and added to it.
To reactivate pairing mode, turn off the lamp by pressing the button on the bottom. Then
turn the lamp on and off three times in a row and finish with on. When the lamp starts pulsing,
pairing mode is activated. Wait 10 seconds between each attempt.
5
Connecting to Ikea Trådfri: Make sure the lamp is charged and turn the lamp on by using the
on-off button on the bottom of the lamp. When you turn on a Humble One S for the first time
it is automatically in pairing mode for 3 minutes. The lamp will pulsate to indicate this. After 3
minutes the lamp will shine normally and you can add it to your Trådfri system.
Charging the lamp with cable: Insert the Type-C USB plug into the slot near the bottom of
the lamp. Plug any adapter for a mobile device (with a USB-A output) into the wall socket.
Depending on the wattage of your adapter, charging will take approximately 3-4 hours.
Charging the lamp wirelessly: Place your Humble on any Qi-standard charging dock.
Depending on the wattage of your adapter, charging will take approximately 4-5 hours. There
are three indicator lights located next to the Type-C USB slot. While the battery is charging;
the lights will flash in order for 10 seconds. LED 1 flashing: battery level is 6%-33%. LED 2
flashing: battery level is 34%-66%. LED 3 flashing: battery level is 67%-95%. If the battery is
fully charged, all three LEDs will remain lit. If the battery is almost empty, the last LED light
will continue to blink.
When pressing the (+) button on the bottom or when operating the lamp using the app, the
LED lamps will indicate the battery level. After 10 seconds, these LED lights will switch off.
Charge the lamp if it no longer lights up. If the battery will not charge, contact your Humble
dealer.
Changing the bulb
The Humble One S contains a LED light bulb that you can replace by yourself. Please note
that the Humble One S base only works with low-voltage Humble bulbs. When the light
source reaches the end of its life, please replace with an original Humble bulb available at:
www.humblelights.com
EN
6