Power Dynamics CSBA3 Manual De Instrucciones página 4

INSTALLATION AND CONNECTION OVERVIEW
1. Drill a hole in the ceiling, big enough to fit the speaker (sizing below).
2. If the PA system is turned on, turn it off before making any connection.
3. Connect the speaker via two cables to the sound system (see below for a connection overview); when connecting several
speakers, make sure that all speakers have the same polarity and that the amplifier is not overloaded. Before starting with
the installation, you must clarify how many speakers you would like to install in the room.
4. Insert the speaker in the hole.
5. Use the spring clamps to secure the speaker.
Connect the speaker(s) to the 100V amplifier output, using a two-core 100Volt suitable cable.
If you are connecting multiple speakers, make sure that all speakers have the same polarity and that the amplifier is not
overloaded.
Always make sure that the output signal is not distorted and that your speakers will not get damaged.
When distortions can be heard, either the amplifier or the speaker is overloaded. In order to avoid damage, reduce the volume
immediately when distortions can be heard. When speakers are destroyed by overload, the guarantee becomes void.
Cabling of a 100 Volt system belongs to an electrical installation which may only be carried out by a qualified electrician!
The total load must not exceed the rated power of the amplifier. Before starting the installation, make clear how many speakers
you want to install in the room and with what wattage(s), as overload will damage the amplifier and speaker.
Always insulate the unused connection cables.
4