Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING THE SHRREDDER: (See Fig. 4)
•
Press the I/O switch to "I'' to start the motor (Fig.4)
•
Press the circuit breaker button if the machine
does not work, ensure you have connected to
power supply.
•
When the motor has been running for a few
seconds you can commence shredding.
WARNING:
The circuit breaker will be activated in the following
circumstances:
•
A build up of shredded material around the cutting
disc.
•
If the material being shredded is greater than the
motor capacity.
•
Where there is too much resistance against the
cutting blade.
When the circuit breaker has been activated, switch off
the shredder and disconnect the power supply.
a. Unscrew the reamer knob at the base of the turret
and open top section.
b. Remove the debris or obstruction from the cutting
area.
c. Return the top section and tighten the reamer knob.
d. Leave motor a few minutes to cool down.
e. Reconnect to the power supply and press the circuit
breaker button.
f. When ready to start shredding, switch to "I'' .
STOPPING THE SHREDDER: (See Fig. 5)
•
Push the I/O switch to "O" to turn the garden
shredder off.
•
Disconnected to the power supply.
Stop
OPERATION INSTRUCTIONS
Start
8
Model GS015
WARNING:
Never slacken off the tightening knob(11) without
having turned off the On/Off switch and pulled the
plug out off the socket.
WARNING:
The shredder will stop within 5 seconds after
switching off.
USING THE PADDLE
There is a paddle provided to aid feeding less bulky
material such as small twigs, leaves, other garden
waste and vegetation into the in-feed chute.
•
Load the material into the hopper.(Fig.6)
•
Insert the paddle(8) into in-feed chute pushing
material onto the blade disc.(Fig.7)
•
Wait until all the material has been shredded
before adding more material.
NOTE: Your fingers must never enter the in-feed
chute.
NOTE: Never use the tool if the hopper is not
fitted.
NOTE: Do not over reach.
Publicidad
