Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
DALTON
REF. A19361509S | A19361509A
A - INSTALAÇÃO PAREDE
Depth:60MM
GENERAL SAFETY INFORMATION
_____________________________________________________________________________
>
To reduce the risk of death, personal injury, fire, electric shock,
falling parts, cuts / burns and other hazards, read all warnings and
instructions included with the appliance box as well as all labels.
>
Before installing or maintaining this equipment, follow the
instructions in this manual. For a residential installation, if you
are unsure whether to install or maintain the luminaire, consult a
licensed and qualified technician.
>
DO NOT INSTALL THE PRODUCT IF THE SAME IS DAMAGED
>
To prevent injury or damage to the assembly of this product, make
sure the conductors and screws are secure before connecting the
power.
>
Young children should be supervised to ensure that they do not
play with this product.
>
Handle the installation carefully to avoid any damage or breakage.
>
For installation, select an appropriate location away from liquids
and hazards. Make sure that the connection does not come into
contact with corrosive materials or surfaces, chemicals, etc.
>
Turn off the power and let it cool before cleaning. To clean, use a
clean, damp cloth. Never immerse the appliance in water.
>
Lamp replacement and maintenance: disconnect power and allow
fitting to cool down before cleaning or replacing.
>
Check that the supply voltage is correct compared to the
informative label of the luminaire.
A - INSTALLATION INSTRUCTIONS - WALL
_____________________________________________________________________________
①
Prepare the lamp, accessories and tools.
②
Drill two Φ8mm holes with a depth of 60mm in the wall.
(Figure 1).
③
Fix the bushings in the holes. (Figure 2)
④
Then use a wrench to fix the lamp to the wall with anchors.
(Figure 3)
B - INSTALAÇÃO POSTE RETO
U-shpaed Bracket
20°
10°
Loosen the screws here
to adjust angle.
B - INSTALLATION INSTRUCTIONS - STRAIGHT POST
_____________________________________________________________________________
①
Prepare the lamp, accessories and tools.
②
Remove the spacer nut from the U-shaped brackets (Figure 1).
③
Use the U-shaped brackets to fix the lamp on the pole. (Figure 2)
④
Loosen the screws at both ends of the bracket and adjust the
angle of the fixture as needed, which is 20° clockwise adjustable and
10° counterclockwise adjustable and tighten the screws. (Figure 3
and 4).
* This installation applies to posts with a diameter of Φ40-60mm.
C - INSTALLATION INSTRUCTIONS - CURVED POST
_____________________________________________________________________________
①
Prepare the lamp, accessories and tools.
②
Loosen the screws and remove the support. (Figure 1 and 2)
③
Move the lamp base cover. (Figure 3)
④
Attach the arc-shaped bracket to the lamp base (do not tighten
the screws). (Figure 4)
⑤
Place the lamp on the pole. (Figure 5)
⑥
Adjust the lamp and balance it, then tighten the arc-shaped
bracket. (Figure 6)
* This installation applies to posts with a diameter of Φ40-60mm.
IMPORTANT
_____________________________________________________________________________
1. This is a solar energy lamp, please install it in a place where it can
get plenty of sunlight.
2. Lighting time depends on the duration of sunlight and working
mode.
3. During the day, even when turned off, the luminaire can charge
the solar batteries.
4. Do not put the battery in household waste to avoid explosion.
5. The luminaire is equipped with an internal battery, which can be
replaced.
6. The light source and separate control device can be removed by a
qualified person without permanent damage to the luminaire.
C - INSTALAÇÃO POSTE CURVO
[ EN ]
1
Publicidad
