GE PVM1790 Instrucciones De Instalación página 21

Installation Instructions
ADAPTING BLOWER FOR
RECIRCULATION (continued)
Place the blower unit back into the opening.
ACcauTION: Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
C3
| 6 | Secure blower unit to oven with the screw removed
in Step 2. Insert the screw in bottom right screw
hole on the back of the oven.
Replace blower plate with the screws removed in
Step 1.
v ¢~<_— Blower Plate Screws
. ~~ Back of Oven
Blower Motor
Screw
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
Screws.
21
NOTE: When mounting the
oven, thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift oven
by pulling cord Lift oven, tilt it forward,
and hook slots at back
bottom edge onto two
lower tabs of mounting
plate.
;
Rotate front of oven up
against cabinet bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely tightened
later.) Be sure to keep power cord tight. Be careful
not to pinch the cord, especially when mounting
flush to bottom of cabinet.
Cabinet Front
SJ, Cabinet Bottom Shelf
4 / Filler Block
Oa 4
"Mi,
Equivalent to Depth
\ Self-Aligning Screw
of Cabinet Recess
Oven Top
| 4 |Attach the oven to the top cabinet.