Publicidad
Idiomas disponibles
Idiomas disponibles
▪ Check that all screws are properly tightened. Regular
inspection is important to ensure safety issues and the
performance of the power tool;
▪ After the accessories assembly and before using the
power tool, test it at full speed with no load for a while.
Check for moving parts misalignment or any other
condition that may affect the combi drill operation.
Check that all moving parts run smoothly, without
abnormal noises;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or worn
out;
▪ If the ON/OFF switch is damaged or does not allow the
operation of the tool to be controlled, it must be repaired
or replaced in order to prevent any accidental start.
Make all adjustments and work necessary for the correct
assembly of the combi drill. If you have any questions or
difficulties, contact your official distributor.
Keep third parties away from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to 300
lux), thus decreasing the risk of accidents.
Always wear personal protective equipment and clothing.
Wearing a visor or goggles, dust mask, hearing protection,
anti-slip safety shoes, long-sleeved clothing, gloves and
helmet properly reduces the risk of injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler suit.
Do not wear loose clothing or jewelry. Keep hair, clothing
and gloves away from moving parts.
The control and safety devices installed must not be
removed or inhibited.
To avoid accidents, you should also take into consideration
the following precautions and procedures:
▪ The rotating accessories speed of the combi drill must
be at least equal to the maximum speed stated in the
technical specifications;
▪ When operating the combi drill, place yourself in a
stable position and always keep your balance. Hold the
appliance firmly to ensure continuous operation and
withstand unexpected situations, such as kickback;
▪ The kickback is a sudden reaction that happens when
the power tool is switched on and the rotating accessory
gets jammed. The rotating accessory kickback forces the
power tool to rotate in the opposite direction to the
rotation of the accessory;
▪ The kickback occurs due to an incorrect use of the power
tool or due to an improper working procedure which can
cause serious injuries to the user. Loss of control can
result in serious injury. To avoid the kickback, the
following precautions must be considered:
- Place the rotating accessory in the correct position and
keep it securely locked in place;
- Do not position your body in the area where power tool
will move if kickback occurs;
▪ Never put your hands near the rotating attachment. Keep
your hands away from the rotating parts;
▪ When the rotating accessory gets jammed, switch off the
tool immediately;
▪ To avoid displacements or projections use a fixing device
or a bench vice to ensure a safe performance;
Place/maintain the workpiece in a correct and stable
position;
▪ Never put the tool down before the rotating accessory
has completely stopped. The rotating accessory may
grab the surface, causing you to lose control of the
power tool;
Publicidad
