GE Profile DPSR473EW0AA Manual Del Propietário página 13

Before you call for service...
Troubleshooting tips
Save time and money] Review the charts on the following
pages first and you may not need to call for service.
Possible Causes What To Do
Dryer is unplugged
• Make sure tile duet plug is pushed completely into
tile outlet.
Fuse is blown/circuit breaker is • Check tile house tnse/circuit breaker box and
tripped replace fllse or reset breaker.
NOTE: Most electric
(hyers use two filses/breakers.
Dryer doesn't heat
Fuse is blown/circuit breaker is • Check the house filse/drcuit breaker box and
tripped, the dryer may tumble replace fllse or reset breaker.
but not heat
Gas service is off
• Make sure gas shutoffat
&yer and main shutoffare
fillly open.
Dryer shakes ormakes Some shaking/noise is normal. • Move (hyer to an even floor space, or a(!just
noise Dryer may be sitting unevenly leveling legs as necessa U until even.
Greasy spots on clothes Improper use of fabric softener • Follow directions on lid)tic softener package.
Drying dirty items with clean ones • Use your duet to d U only clean items. Dirty items can
slain clean items and the &yer.
Clothes were not completely clean • Sometimes st_fins which cannot be seen when tile
(lothes are wet appearafier duiug. Use proper
x_;tshing procedures beti)re &ying.
lint on clothes Lint filter is full • Clean lint s(reen betbre each load.
Improper sorting • Sort lint producers (like chenille) from lint collectors
(like corduroy).
Static electricity can attract lint • See suggestions in this section under STATIC.
Overloading • Separate large loads into smaller ones.
Paper, tissue, etc., left in pockets • Empty all pockets betore laundering clothes.
Static occurs No fabric softener was used • T U a ihbric softener.
• Boun(e _PFabric (_onditioner D_yer Sheets have
been approved fi)r use in all liE Ihyers when used in
ac(ordance with the manufacturer's inslnactions.
Overdrying • T D"a fhbric sofieuer.
• At!jllSl controls ti)l" less (h)4ng.
Synthetics, permanent press and • TD_ a thbric softener.
blends can cause static
Inconsistent drying times Type of heat • Autom;ttic dD_ing times xdll vmy accorcfing to the type
of heat used (electric, natural or l A' gas), size of h)ad,
types of fabrics,
wemess of clothes and condition of
exhausl ducls.
12