Safety Instructions
1. Handle with care.
2. Avoid exposure to direct sunlight for extended periods of time.
3. To avoid injury, DO NOT lean against lid when being used.
4. Ensure waste tank is cleaned regularly.
Maintenance
1. Lubricate Slide Valve seals periodically with silicone spray or white grease lubricant.
2. Clean exterior of toilet with a mild, non-abrasive bathroom cleaner.
Operation/How to use:
1. Fill upper water tank with clean water (Fig.1)
2. Pull out slide valve handle before use. (Fig. 2)
3. Caution: Always press the vent button to release air pressure inside the waste holding tank to
avoid waste spills before opening the slide valve.
4. 3. Flush the toilets by depressing piston pump up and down 2 or 3 times. (Fig. 3)
5. 4. After ush, push the handle back in. (Fig. 4)
To empty holding tank:
1. Empty the waste holding tank when the level indicator turns from green to red. (Fig.S)
2. Make sure the slide valve is closed and separate two tanks by disengaging side latches. (Fig.6)
3. Carry holding tank to permanent toilet facility. (Fig.7)
4. Remove the cap of rotating empty spout.
5. Empty contents into permanent toilet (*Press the vent button to avoid splash) (Fig.8)
6. Rinse tank thoroughly. Reassemble unit and prepare for next use.
Storage:
To store Portable Toilet when not in use:
1. Empty the top tank and waste holding tank.
2. Make sure all water is cleared from the ush pump by depressing pump several times.
3. Stored away from direct sunlight.
Note: A small amount of water may remain in the top tank but will be harmless during storage.
www.serenelifehome.com
3