Publicidad
O
PERIODIC INSPECTION
recorded on the product's lifesheet. Keep all inspection and reference documentation for the entire life of the
Fabric components
• presence of cutting and/or burning cuts and/or burns on the load-bearing straps
• presence of cutting and/or burning on the load-bearing stitchings
•
•
Metal components
•
•
to be greater than 1 mm;
•
•
•
sandpaper);
• presence of permanent deformations;
• operative problems that cannot be resolved through cleaning or lubrication.
• the connector or ventral ascender can be replaced with the same model
If the component or one of its parts shows signs of wear or defects, it must be replaced, even before the end of
its expected lifetime.
occurred, even no external signs are visible.
LIFETIME
freezing, sweat, mud, dust, improper use or storage other than what is recommended. If a product is suspected to
be no longer safe and reliable, replace the product or contact C.A.M.P. SpA or the distributor before continuing use.
TRANSPORTATION
n case of one of the following defects are present, the product should
34
It must be replaced if there is
The product lifetime is understood to
Publicidad
