Würth AFP 18-A Manual De Instrucciones página 14

SPECIFICATIONS
VOLTAGE 18V d.c.
NO-LOAD SPEED 75 g/min
POWER PRESSURE 6250 psi
TOOL WEIGHT 3.75 kg (Battery 0.65kg)
ACCEPTABLE GREASE Up to NLGI #2
CHARGING TIME 1Hour
OPERATING INSTRUCTIONS
(SLIDE-IN)
Installing or Removing Battery Pack (See
Fig.1 Fig.2)
1. Always switch off the machine before insertion or
removal of the battery pack.
2. To remove the battery pack, push the button on the
battery pack and pull the tool unit from the battery
pack in the direction.
3. To insert the battery pack, align the tool unit slides
with the battery pack sliding groove and push the
tool unit into place. The tool unit can be slide into
battery pack in two directions.
4. Do not force the battery pack in sliding it into tool
unit. If the battery pack does not slide in easily, it
is not being inserted correctly.
Charging the Battery Pack (See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the
arrow direction shown on the charger.
3. Push the battery pack into place and make sure
the red light on the charger is "ON". The battery
pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn
into green. The battery pack is now ready for use.
5. Your new battery pack is not charged. You need to
charge it before use.
6. Always use the specified charger to charge the
battery. When the battery pack is inserted
into thecharger correctly, the red light will come on
and charging will begin. .
7. When you charge a new battery pack or a battery
pack which has not been used for a long period,
14
it may not accept a full charge. This is a normal
condition and does not indicate a problem.
You can recharge the battery pack fully
after discharging it completely a couple of times.
8. Unplug the charger from the power source after
finishthe charge.
9. Please remove the battery from the unplugged
charger for storage.
The Battery Pack has a "SW" button and 4-step
green LEDs for indicating
remaining capacity status and Over temperature
condition.
The remaining capacity (RC) and temperature protec-
tion status green LED
indications ( 3 second ) when the "SW" button is
momentarily pressed.
LED INDICATION FUNCTION
LED 1 (green) 0%- 25%
LED 1, 2 (green) 26%-50%
LED 1, 2, 3 (green) 51%-75%
LED 1, 2, 3, 4 (green) 76%-100%
LED 1 Blinking (0.25Sec/green) Fully Depleted
LED 1, 2, 3, 4 Blinking (0.5sec/ green)
Over Temperature condition
LED INDICATION FUNCTION
The LED Light on the Charger
Power On
(Green light flashes slowly)
Battery Low
(Red light stays illuminated)
Battery charged 80%
(Green light flashes rapidly)
Battery charged 100%
(Green light stays illuminated)