MPM MOD-71 Manual De Instrucciones página 34

EN
4. Disconnect the charger (17) from the mains supply and the charger cable from the battery (6).
Fig. 3
1. Connect the charger (17) to the mans supply and then to the handle
(15) fixed on the wall (fig.4).
2. Slide the vacuum cleaner to bracket mounted on the wall (15); the
battery charging process will begin (6).
3. Once fully charged, the appliance will automatically stop the charg-
ing process, so the charger can be plugged in for a long time with-
out damaging the battery.
USING THE VACUUM CLEANER
1. Make sure the vacuum cleaner is properly assembled and the bat-
tery is charged.
2. Connect the relevant equipment:
- multi-purpose electric brush with illumination (5) - for all types
of hard surfaces and carpets, LEDs illuminate the surface to be cleaned for perfect vacuuming
An additional velour roller is included with the electric brush for vacuuming smooth surfaces.
- crevice attachment (12) – vacuuming of corners, spaces under the furniture and anywhere
where access to free use of other accessories is limited.
- upholstery attachment (13) – dedicated to vacuuming couches, sofas, armchairs and car up-
holstery, etc.
- attachment with hair (14) – is used for removing dust from books, lampshades, frames, deco-
rations, curtains, etc. Brush hairs additionally detach extremely stubborn dirt from the surface
to be cleaned
Depending on the needs, connect the equipment to the suction pipe or motor unit (2).
1. Start the vacuum cleaner with a switch. The vacuum cleaner will operate in the AUTO mode. While
the vacuum cleaner is running, the switch can be locked by moving the locking switch key to the
left or right (fig.5).
2. In order to switch to one of the operating modes (AUTO, MAX or ECO), touch the "papillary line"
icon.
34
Fig. 4