Descargar Imprimir esta página

Kesser WQ-8010 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

TROUBLESHOOTING GUIDE
Read and follow the instructions.
Check that the power supply has not been interrupted.
Dry the hob thoroughly after cleaning.
If alphanumeric codes appear on the display when the hob is switched on, see the table below
for instructions.
If the hob cannot be switched off after use, disconnect it from the power supply.
Error Code
E1
E2
E3
E4
E5
E6
E7
Noise from the hob
Induction hobs can cause whistling or crackling during normal operation. These actually come from
the pots and pans due to the characteristics of the bottom (e.g. bottom made of several layers of
material or uneven bottom).
These noises vary depending on the pots and pans used and the amount of food they contain and
do not indicate a defect of any kind.
In addition, the induction hob is equipped with an internal cooling system to regulate the temperature
of electronic parts. As a result, the sound of the fan is audible during operation and for a few minutes
after switching off the hob.
This is completely normal and essential for the proper functioning of the unit.
Energy saving
For best results it is advisable to:
Use pots and pans with a base width that corresponds to that of the cooking zone.
Only use pots and pans with a flat bottom.
If possible, keep the pot lids on during cooking.
Use a pressure cooker to save even more energy and time.
Place the pot in the centre of the cooking zone marked on the hob.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
Possible Causes
Low voltage
High voltage
IGBT thermistor short or open
Surface thermistor short or open
High temperature surface
High-temperature IGBT
Display error
Check voltage / replace mainboard
Check voltage / replace mainboard
Replace the motherboard
Check if the thermistor has become loose/
Replace the thermistor has loosened
Switch off the power and let it cool down
Wait until the IGBT has cooled down/
Replace the motherboard
Check the connection between the main
board and the display light board/ Replace
the light board
www.eshopping.de
Solutions

Publicidad

loading