Jackery Explorer 1000 Manual De Instrucciones página 5

7
AC Wall Charging Indicator
10 Battery Power Indicator
13
Fault Code
16
Energy Saving Mode
19 Remaining Discharge Time
EPS: Emergency Power System.
Once you have connected the mains and the AC input port of the product via the AC charger cable,
you can use the AC output port of the product to power your unit (at this point the AC power comes
from the mains, not the battery of the product). In the event of a sudden loss of mains power, the
product can automatically switch to battery mode within 20ms. Since this is a non-professional UPS
function, it does not support 0ms switching. Do not connect to equipment with high uninterruptible
power requirements such as data servers and workstations. Please test several times to confirm
compatibility before use and it is recommended to connect to only one device. Do not use more than
one unit at a time to avoid triggering the overload protection. Failure to follow these instructions may
result in equipment failure or loss of data for which we cannot be held responsible.
Battery Power Indicator
When the product is being charged, the orange circle around the battery percentage will light
up in sequence. When charging other devices, the orange circle will stay on.
Low Battery Indicator
When the battery is less than 20%, the Low Battery Indicator will stay on. When less than 5%,
the Low Battery Indicator will flash. When it is being charged, this Indicator will be o .
Energy Saving Mode
To avoid forgetting to turn off the output which results in battery consumption, the product
turns the Energy Saving Mode on by default. This occurs when no device is connected or the
connected device is less than or equal to a certain value (Refer to the table below for more
details), the device will automatically turn off all outputs after 12 hours.
Output
AC Output
USB Output
Car Output
To turn o the Energy Saving Mode
Long press the AC Button and Main Power Button until the Energy Saving Mode icon
disappears. In Non-Energy Saving Mode, please remember to turn o the products to avoid
battery consumption.
8
Car Charging Indicator
11
Low Battery Indicator
14
High Temperature Warning
17
AC Power Indicator
Output Power Defaults
≤25W
All outputs turned o automatically after 12 hours
≤2W
≤2W
9
Solar Charging Indicator
12
Remaining Battery Percentage
15
Low Temperature Warning
18
Output Power
GB
03